Champion 22 TON LOG SPLITTER Manuel du propriétaire Page 14

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 29
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 13
Maintenance Schedule
Check hydraulic fluid _"
i/
/_ FiI! Inservice dates here
Change hydraulicfluid
3=,'-
"- _ Changehydraulicfilter
Q,r-
.t
Checkhoseclamps
:E
Lubricatebeamandwedge
Checkengineoil
q) Changeengineoil _
e-
"-O1 Serviceaircleaner
tit Cleanenginelinkages
engine linkages
Clean
Service spark plug ,/
General Recommendations
Always observe safety rules when performing
any maintenance.
The warranty on this log splitterdoes not cover
items that have been subjectedto operator
abuse or negligence. To receive full value from
the warranty, operator must maintainthe log
splitteras instructed inthis manual.
Some adjustmentswill need to be made
periodicallyto maintain your unit properly.
All adjustments inthe Service and Adjustments
section of this manual should be checked at least
once each season.
Followthe maintenance schedule given above.
Periodicallycheck all fasteners and make sure
these are tight.
,_ WARNING: Always stopthe engine and
disconnect spark plug wire before
performingany maintenance oradjustments.
Splitter Mechanism
Hydraulic Fluid
Check the hydraulic fluid level in the log splitter
reservoir tank before each use. Fluid level should
14
be 1.5" to 2" from the top of the tank (four gallons
approximately).
Change the hydraulic fluid in the reservoir every
100 hours of operation.
Disconnect the suctionhose from the bottom of
the reservoir tank, and drainthe fluid into a
suitable container.
Refill using only Dexron III automatic
transmission fluid or 10W non-foaming hydraulic
fluid. Also change the hydraulic filter.
NOTE: Drain the fluid and flush the reservoir tank and
hoses with kerosene whenever any repair work is
performed on the tank, hydraulicpump or valve.
Contaminants in the fluidwill damage the hydraulic
components (should be performed by your Sears
service center).
Hydraulic Filter
Change the hydraulic filter every 50 hours of
operation. Use only a 10 micronhydraulic filter.
Hose Clamps
Check the hose clamps on the suction hose
(attached to the side of the pump) for proper
tightness before each use.
Check the hose clamps on the return hose at
least once a season.
Vue de la page 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 28 29

Commentaires sur ces manuels

Pas de commentaire