Champion 22 TON LOG SPLITTER Manuel du propriétaire Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 29
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
Never attempt to split woods across the grain.
Some types of wood may burst or fly out of your
splitterand result in injuryto you or a bystander.
For logsthat are notcut square, the longest
portionof the log should be rotated down and
the most square end placed against the splitting
wedge.
Keep your work area clean. Immediately
remove split wood around your splitterso that
you do notstumble over it. Clean chips and dirt
off end plate (wood platform)after each log is
split, orwhenever necessary to maintain flat
contact between wood and end plate (platform).
Never move the togsplitterwhile the engine is
running.
Never leave your log splitterunattended withthe
engine running.Shut off the engine if you are
leaving your splitter,even for a short period of
time. Someone couldaccidentally activate the
splittingwedge and be injured.
Do not run engine in an enclosed area. Exhaust
gases contain carbon monoxide.This odorless
gas can be deadly when inhaled.
Be careful not to touch the mufflerafter the
engine has been running. It will be HOT!
If the equipment should start to vibrate
abnormally, stopthe engine and check
immediately for the cause. Vibration is generally
a warning of trouble.
When cleaning, repairing or inspecting, make
certain all moving parts have stopped.
Disconnect the spark plugwire and keep the
wire away from the plugto prevent accidental
starting.
Customer Responsibilities
Do not operate your splitter inpoor mechanical
conditionor when in need of repair,
Periodically check that all nuts, bolts, screws,
hose clamps and hydraulicfittingsare tightto be
sure equipment is insafe working condition.
Where appropriate, check all safety guards and
shieldsto be sure they are inthe proper position.
Never operate your splitterwithsafety guards,
shields orother protectivefeatures removed.
These safety devices are for your protection.
Replace all damaged or worn partssuch as
hydraulichoses and fittingsimmediately with
manufacturer approved replacement parts.
Do not change the engine governor settings or
overspeed the engine. This increases the
hazard of personal injury. The maximum engine
speed is preset by the manufacturer and is
within safety limits.
Do not alter your log splitter in any manner such
as attaching a rope or extension to the control
lever or adding to the width or height of the
wedge. Such alterations may cause your splitter
to be unsafe.
Perform all recommended maintenance
proceduresbefore you use your splitter.
Do notservice or repair your log splitterwithout
disconnectingthe spark plugwire and movingit
away from the spark plug.
Never storethe equipment withgasoline inthe
tank inside of a buildingwhere ignitionsources
are present, such as hot water and space
heaters, clothes dryers and the like. Allow the
engineto cool before storing inany enclosure.
Always storegasoline in an approved, tightly
sealed container. Store the container in a cool,
dryplace. Do not store in a building where
ignitionsources are present.
To reduce fire hazard, keep engine free of grass,
leaves, wood chips, and excessive grease and
oil.
The hydraulicsystem of your logsplitterrequires
careful inspection,along with the mechanical
parts. Be sure to replace frayed, kinked,or
otherwisedamaged hydrauliccomponents.
Fluid escaping from a very small hole can be
almostinvisible. Do notcheck for leaks withyour
hand. Escapingfluid under pressure can have
sufficientforce to penetrate skin, causing
seriouspersonal injury.Leaks can be located by
passinga piece of cardboardor wood over the
suspected leak and lookingfor discoloration.
Should it become necessary to loosenor
remove any hydraulicfitting or line, be sure to
relieve all pressure by shuttingoff the engine
and movingthe control handle back and forth
several times.
Do not removethe cap from the hydraulictank or
reservoirwhile your log splitteris running.Hot oil
under pressure could cause injury.
The pressure relief valve on your splitteris
preset at the factory. Do notadjust the valve.
Onlya qualified servicetechnician should
performthisadjustment.
Completely drain fuel tank priorto storage. This
guardsagainst accumulationof fuel fumes
which couldresult in a fire hazard.
Never store log splitteroutsidewithouta
waterproof cover. Rain will cause ruston the
insideof the cylinder.
Important Information
Always:
Use clean fluid and check fluid level regularly.
Use Dexron III Automatic Transmission Fluid or
10W non-foaming hydraulic fluid.
Use a filter (clean or replace regularly).
Use a breather cap on fluid reservoir.
5
Vue de la page 4
1 2 3 4 5 6 7 8 9 10 ... 28 29

Commentaires sur ces manuels

Pas de commentaire